d from Www.Somanuals.com. All Manuals Search And D
RFS-108 Features:
8 x 10/100Mbps RJ-45 Nway ports
Supports 802.3az Green Ethernet: Detecting port
usage power saving and cable length power saving
Supports NWay protocol for speed (10/100Mbps)
and duplex mode (Half/Full) auto-detection
Supports MDI/MDI-X auto crossover
Supports full and half duplex operation on all ports
Supports back-pressure (half duplex) and flow
control (IEEE 802.3x)
Supports 802.11p QoS data management
Wire-speed packet filtering and forwarding rate
Store-and-forward architecture filters fragment &
CRC error packets
Supports 1K MAC address entries in whole system
768K bits (96KB) buffer memory
FCC Class B, CE
Before you start to install the switch, check the following
contents in this package：
A 5 port RFS-105 switch or a 8 port RFS-108 switch
One external power adapter
User’s manual
d from Www.Somanuals.com. All Manuals Search And D
3
Please refer to the following table for LED definition
5port
8port
LED
Power Steady Green Power is on
Off Power is off
Status
Operation
Link/Act Steady Green The port is connected
Blinking Green The port is transmitting/receiving
data.
Off
No connection
Connect each station to the switch by twisted-pair cable.
Plug one RJ-45 connector into a RJ-45 port of the switch,
and plug the other RJ-45 connector into the station’s network
adapter. Power on the switch and then system is ready.
For cable selection, refer to the following table.
d from Www.Somanuals.com. All Manuals Search And D
4
In making a switch interconnection, you could use any port to
connect another switch with straight or crossover cable. As
all the ports support auto MDI / MDI-X function, using a
straight cable to make a switch-to-switch connection is
allowed.
For cable selection, refer to the following table：
Network Speed Cable Type
Max. Length
100 meters
100 meters
10Mbps
Cat. 3, 4, 5 UTP/STP
Cat. 5 UTP/STP
100Mbps
d from Www.Somanuals.com. All Manuals Search And D
5
RFS-105 Spec
Switch Type
Desktop
802.3 Ethernet, 802.3u Fast
Ethernet, 802.3x Full-Duplex
Flow Control, 802.3az Energy
Efficient Ethernet
Standards
Network Management
Type
Unmanaged
Ports
5 x RJ45
Speed
10/100Mbps
1K
MAC Address Table
Buffer Memory
Switching Method
384K bits (48KB)
Store and Forward
System: Power
Port: Link/Act
LEDs
Power
External Power 5V0.6A
4.76" x 2.95" x 1.02" (121 x
75 x 26 mm)
Dimensions
Weight
0.57 lbs. (258.55g)
Temperature
Humidity
0ºC to 40ºC (32ºF to 104ºF)
10% - 90%, Non-condensing
d from Www.Somanuals.com. All Manuals Search And D
6
RFS-108 Spec
Switch Type
Desktop
802.3 Ethernet, 802.3u Fast
Ethernet, 802.3x Full-Duplex
Flow Control, 802.3az Energy
Efficient Ethernet, 802.1p
QoS data management
Standards
Network Management
Type
Unmanaged
Ports
8 x RJ45
Speed
10/100Mbps
1K
MAC Address Table
Buffer Memory
Switching Method
768K bits (96KB)
Store and Forward
System: Power
Port: Link/Act
LEDs
Power
External Power 5V0.6A
6.08" x 2.95" x 1.02" (155 x
75 x 26 mm)
Dimensions
Weight
0.76 lbs. (345g)
Temperature
Humidity
0ºC to 40ºC (32ºF to 104ºF)
10% - 90%, Non-condensing
d from Www.Somanuals.com. All Manuals Search And D
7
FCC Certifications
This Equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct
the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received; including interference that may cause undesired operation.
CE Mark Warning
This equipment complies with the requirements relating to
electromagnetic compatibility, EN 55022 class B for ITE, the essential
protection requirement of Council Directive 2004/108/EC on the
approximation of the laws of the Member States relating to
electromagnetic compatibility.
Company has an on-going policy of upgrading its products and it may
be possible that information in this document is not up-to-date. Please
check with your local distributors for the latest information. No part of
this document can be copied or reproduced in any form without written
consent from the company.
Trademarks:
All trade names and trademarks are the properties of their respective
companies.
Copyright © 2012, All Rights Reserved.
d from Www.Somanuals.com. All Manuals Search And D
8
|