Color Observation Camera
SOD14DC
SSC-21DC
User's Guide
d from Www.Somanuals.com. All Manuals Search And D
Overview
Part Names and Function
CCTV COLOR DOME CAMERA is the monitoring
camera incorporated with the recent CCD that
provides the best monitoring function in connection
with the CCTV system equipment.
a
b
d
e
c
✔
Number of CCD pixels
•
270,000 pixels
a
Fixed Focus Lens
Fixed-focus that has a lens attached to the camera.
Keep the camera free of dust or dirt.
✔
✔
Power supply
•
•
SOD14DC : DC12V From Monitor(SOD-14M)
SSC-21DC : DC12V From Monitor(SSC-21M)
b
PCB Board
It is an important part of the camera that carries out the
main function.
Automatic function and special function
Handle with care.
•
•
ATW
ELC(Electronic shutter iris)
c
Camera Frame
Frame that provides support to the camera.
✔
SOD14M(Monitor) only
d
e
Dome Cover
Clear plastic cover that protects the camera.
Take care not to scratch the cover.
6Pin modular jack
Used to connect the monitor.
2
3
Installation
✔
Check what is inside the package
•
Check to see if the following parts are included in
the purchased package.
!@#$%^
PIN NUMBER
SPEC
N.C
1
2
3
4
5
6
Camera
tab screw
User’s guide
VIDEO_OUT
GND
N.C
✔
Notes on installation and usage
N.C
1. Users should not disassemble the camera from
the front direction.
12V DC
2. Always handle the camera with care.
Please do not apply a shock or vibration as
much as possible and take cautions not to cause
damage or make a scratch on the camera due to
careless storage.
✽
Fixed Dome Camera does not support alarm in
feature or audio feature.
3. Please do not install the camera with the rainy
place or highly humid areas. And do not operate
the camera in the wet place.
4
5
4. Do not clean the camera body with the strong
abrasives or soaps. When the camera becomes
dirty, clean it with the dry rugs. Especially, make
sure to use the dedicated rugs for lens to clean
the dome cover.
•
Connect the camera cable to the camera cable
jack on the dome camera, then connect,and the
other end of the cable to the monitor s channel
input jack.
5. Please select the camera in the cool area that is
not exposed to the direct sunlight. If you do, it
can cause bad effects on the product.
✔
Cable connection
•
Remove the dome cover from the main body of
the camera by turning the cover in a counter
clockwise direction with one hand while holding
the body with the other.
< SSC-21DC >
< SOD14DC >
6
7
•
Attach the camera to the wall or ceiling using the
supplied tap screws.
•
Put the dome cover back on the camera by
rotating the cover clockwise.
Wall or ceiling
Main body
Screw Driver
Tab screw
Caution : When removing or closing the dome cover,
do not get dirt or dust on the cover.
•
Adjust the video location by swiveling the camera
(PCB board) up and down, and adjust the focus
by turning the lens clockwise and counter
clockwise.
Wall or ceiling
Adjust the
image upward
or downward
Adjust focus by
turning left or right
8
9
Specifications
SOD14DC / SSC-21DC : Fixed Dome Camera
Shutter System
SSC-21DC : Electronic Shutter lris
Operating Temperature -10 ~ + 50°C
Model Name
SOD14DC / SSC-21DC
NTSC STANDARD
Power Source
Power Consumption
Dimensions
Weight
DC 12V
Broadcast System
Imaging Device
Approx. 2W
SOD14DC :1/4”SUPER HAD IT CCD
SSC-21DC :1/3”SUPER HAD IT CCD
510(H) x 492(V)
57(W)X47.2(H)X100.5(L)
SOD14DC :130g
SSC-21DC :150g
Effective Pixels
Synchronization
Resolution
Internal
SOD14DC :H : 330 TV Lines,
V : 350 TV Lines
SSC-21DC :H : 330 TV Lines
VBS 1.0Vp-p(75ohm composite)
SOD14DC :≤48 dB
Signal Output
S/N Ratio
SSC-21DC :≤50 dB
Minimum Object
Illumination
Gamma Correction
Lens
SOD14DC :2lux(F2.0, 50 IRE)
SSC-21DC :0.2lux(F2.0, 50 IRE)
0.45
Focal Length (f) : 3.8mm,
Relative Aperture (F) : 2.0
Electronic Shutter lris
Auto Exposure
I/O Connectors
SOD14DC :Modular jack
SSC-21DC :A/C input, Video outputs:
MODULAR CABLE(60ft)
10
11
|